Maintenance methods for intelligent sewing machine

Maintenance method for intelligent sewing machine:
The application of intelligent sewing machines requires frequent cleaning and lubrication to ensure the normal operation of the machine.
1. Sorting of the sewing machine, sorting of the feeding teeth, removing the screws between the needle plate and the feeding teeth, removing cloth fuzz and dust, and adding a small amount of sewing machine special oil.
(2) The sorting of the sewing disc is the core of the sewing disc machine's work and also the most prone area to problems. Therefore, it is necessary to regularly remove dirt and use a small amount of specialized sewing machine oil.
(3) The surface and various parts inside the sewing machine for other parts should be cleaned regularly.
2. The oiling and lubrication of the intelligent sewing machine must use specialized sewing machine oil. After a day or several days of continuous use, the sewing machine should be fully oiled. If refueling is needed between uses, the machine should be idle for a period of time to allow the oil to fully saturate and shake off excess oil. Then, use a clean soft cloth to wipe the machine head and countertop clean to avoid dirtying the sewing material. Then thread and sew the torn fabric, using the motion of the sewing thread to wipe it clean, throwing out excess oil stains until there are no oil stains on the torn fabric, and then proceed with formal sewing.
The refueling parts include:
(1) The various oil holes on the machine head are used to lubricate the upper shaft and the components connected to the upper shaft.
(2) The components inside the disk and the moving parts connected to each component. Lubricating the presser foot rod, needle rod, and the components connected to them.
(3) Wipe the moving parts of the needle components clean and add less oil. The amount of fuel added to each refueling hole and refueling area should not be too much, just one or two drops are sufficient.
Secondly, the maintenance of the sewing machine should also pay attention to the following points:
After completing the work, insert the machine needle into the needle hole plate, lift the presser foot, and cover the machine head with a machine cover to prevent dust debris from entering. At the beginning of work, first check the main components, the weight of the stepping, whether there are any special sounds, and whether the needle is normal. If any abnormal phenomena are found, they should be repaired in a timely manner. After a considerable period of use, the machine needs to undergo a major overhaul. If any parts with significant wear and tear are found, they should be replaced with new ones.