Maintenance and upkeep methods for intelligent sewing machine

Maintenance method for intelligent sewing machine:
The use of intelligent sewing machines should ensure frequent cleaning and lubrication to ensure the normal operation of the equipment.
1. Cleaning up the sewing machine, cleaning up the feeding teeth, removing the screws between the needle plate and the feeding teeth, eliminating cloth fuzz and dust, and adding a small amount of specialized car oil for the sewing machine.
(2) Cleaning up the sewing disc is the key to the operation of the sewing disc machine, and it is also the simplest local problem. Therefore, it is necessary to regularly eliminate waste and use a small amount of specialized car oil for sewing disc machines.
(3) The surface and inner parts of the specialized sewing machine for other parts should be cleaned regularly.
2. The refueling and lubrication of intelligent sewing machines must use specialized sewing machine car oil. After continuing to use for a day or a few days, the special type of sewing machine should be fully oiled. If refueling is needed during use, the equipment should be idle for a while to allow sufficient oil to penetrate and remove unnecessary oil. Then, use a clean thin cloth to wipe the machine and cabinet countertop clean to prevent dirtying the sewing material. Then assemble the thread and sew the shredded fabric strips. Use the fitness exercise of sewing disc thread to clean them, and throw out unnecessary oil stains until there are no oil stains on the shredded fabric strips. Then proceed to declare sewing.
The refueling parts include:
(1) Each oil inlet on the engine is used to lubricate the upper shaft and its connecting components.
(2) The components inside the disk and the theme activity components connected by each component. The components that connect the lubrication presser foot rod, needle rod, and the two.
(3) Wash the theme activity area of the needle components and add less oil. The amount of fuel added to each refueling hole and refueling area does not need to be too much, just one or two drops are enough.
Secondly, maintenance and upkeep of the sewing machine should also pay attention to the following aspects:
After finishing work, insert the machine needle into the needle eye board, extend the presser foot, and also use the hood cover to start the machine to prevent debris from entering. When starting work, first check the key parts, check the light and heavy conditions when stepping on them, whether there is a common sound, and whether everything is normal with the needle. If any abnormal situations are found, they should be repaired immediately. After a very long period of use, the equipment needs to be repaired. If significant damage is found to the parts, they should be replaced with new ones.